CirKits.com LVD1 Features and Specifications
(c) 2012 CirKits.com
- Features
- Designed for automatic control of 12V solar-powered DC systems.
- Three modes: Off, Auto-On and Manual-On.
- Adjustable shut-off and turn-on voltages.
- Adjustable low-voltage warning voltage with hysteresis action.
- Operates from 12V solar power systems, DC power supplies and automotive power systems.
- Common Negative Ground between 12V power source and external load.
- Designed to work with the CirKits SCC3 solar charge controller kit.
- Reliable and efficient solid-state circuitry.
- Built-in fuse for short circuit protection.
- Radio quiet, will not interfere with sensitive radio receivers.
- Four screw power/load connector will accept spade lugs or wires.
- Miniature three screw connector for remote low-voltage warning.
- Low-voltage warning is isolated, can pull-down or pull-up.
- Controls and Indicators
- On/Off toggle switch.
- Auto-On/Manual-on toggle switch with momentary action for Manual-on.
- Red Load-on LED and amber Low-Voltage LED.
- Built-in green Calibration LEDs.
- Jumper for disabling Calibration LEDs to save power.
- Low Voltage Shutoff adjustment trimmer RV1, range: 8.4V-11.9V.
- Low Voltage Warning adjustment trimmer RV2, range: 9.2V-12.5V.
- High Voltage Turn-on adjustment trimmer RV3, range: 10.0V-14.1V.
- Specifications
- Battery Voltage: 12V (nominal).
- Battery Voltage Range: 9V to 16V.
- Absolute Maximum Operating Voltage: 18V.
- External Load Voltage: 12V DC (nominal).
- External Load Current: 0 to 15 Amps DC.
- On Current, excluding load: 25mA @12.8VDC.
- On Current, low voltage LED on: 27mA @10.0VDC.
- Off Current: 12mA @10.0VDC.
- Voltage drop with 2A load: 0.06V
- Voltage drop with 15A load: 0.5V
- Low Voltage Detect Hysteresis: 0.25V with R7=2M.
- Fuse Rating: 15 Amp standard ATO automotive fuse.
- Board Dimensions: 3.5" wide by 2.9" deep by 0.85" tall.
- Board Mounts: 4X 4-40 screws on 1/4" spacers.
- Assembled Weight: approximately 66 grams (2.3oz).
Go Back to the LVD1 kit page.